Rena Envelope Imager CS Bedienungsanleitung PDF herunterladen (Seite 34)

SECTION 4

MAINTENANCE

Disposing of Inkjet Cartridges

The cartridge may be disposed of in a normal manner.

If there should be an ink spill, use soap and water to clean up any problem areas. Abrasive soap works

well to get the ink off hands.

Cleaning the Inkjet Cartridges

The inkjet cartridges (printheads) in the Envelope Imager CS printer are cleaned automatically each time

the machine is turned on or when the printer decides they need cleaning. Normally, no operator

intervention is required. A manually cleaning can be performed by using the features located under the

Printer Driver Properties, Services tab. See the section titled “Printer Driver Properties” for more details.

Replacing the Sheet Separators

The sheet separators insure separation of the pieces as they are being fed. They do wear and must be

replaced from time to time. If you experience double sheet feeding and can not adjust the separators to

prevent it, the sheet separators should be replaced. Replacement of the sheet separators is not difficult.

Just follow the steps below:

1. Turn off the Envelope Imager CS and unplug it from the power source.

2. Move the adjustable side guides to its

maximum open position. Release the

separator-by loosening knob [A].

3. Lower the separators so that they touch the

feed roller.

4. Remove the screw [B] and the separator

support plate [C.] Then remove the separator

[D] by prying it out of the holder.

5. Install a new separator and then install the

separator support plate and screw.

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 48 49

Keine Kommentare

Rena Envelope Imager CS Bedienungsanleitung Seite 34