L-350 TABBER/LABELER OPERATIONS MANUAL Revised 1-4-13
-8- Figure 8 B 9. Thread the stamps into the L-350 following the LABEL THREADING DIAGRAM [Figure 5]. 10. Position the stamps by moving the entire s
-9- LABEL SENSOR ADJUSTMENT THE L-350 HAS BEEN FACTORY CALIBRATED TO DETECT THE PRESENCE AND ABSENCE OF LABELS UNDER MOST CONDITIONS. HOWEVER, WITH TH
-10- CONTROL PANEL FUNCTIONS A. Label vertical position adjustment in 1/2" increments B. Label vertical position adjustment in 1/32" in
-11- at the edge of the peeling mechanism. If the sensor does not see the label, any attempt to run the labeler will result in failure to feed the med
-12- USING AN OPTIONAL CONVEYOR WITH THE L-350 Warning: Before connecting a conveyor to the power outlet on the L-350, please be sure it meets the fol
-13- 11. With the tabs feeding straight through the clamp, move the two tracking guides [Figure 11A] into contact with the backing paper edge. Tigh
Copyright © 2008 All rights reserved
SAFETY PRECAUTIONS THIS EQUIPMENT PRESENTS NO PROBLEM WHEN USED PROPERLY. HOWEVER, CERTAIN SAFETY RULES SHOULD BE OBSERVED WHEN OPERATING THE L-350.
-1- SPECIFICATIONS L-350 TABBER/LABELER/STAMP AFFIXER DIMENSIONS: 16 1/2" W x 19" H x 18" L SPEED – TABBER: Variable from 5,000 - 20,00
-2- ASSEMBLING THE L-350 1. Remove all packing and parts supplied. Check and identify all parts with the ones listed below. • [A] Envelope Guide 90
-3- THIS STEP CONCLUDES INITIAL INSTALLATION OF THE L-350.
-4- SETUP PROCEDURES BEFORE USING THE L-350, SEVERAL ADJUSTMENTS MUST BE MADE TO SET UP MEDIA THICKNESS AND SIZE MEDIA THICKNESS ADJUSTMENT 1. Loosen
-5- SETTING UP THE L-350 AS A LABELER 1. Remove top exit roller (media pressure roller) by pulling it out of the plastic spring-loaded brackets.
-6- Figure 5a Tabs Only Figure 5 Labels/Stamps SETTING UP THE L-350 AS A TABBER FAN-FOLDED TABS 1. Remove the top exit roller from the plas
-7- SETTING UP THE L-350 TO APPLY STAMPS ROLL OF STAMPS 1. Install the TR-10 Reel Assembly on the machine by hooking the rear bracket to the center t
Kommentare zu diesen Handbüchern