Rena DA615 Bedienerhandbuch PDF herunterladen (Seite 15)

DA615 Operations Manual 3 Rev. 3/23/00

RENA DA615 InkJet Cartridge Removal / Installation Procedure

NOTE: The pictures of the printhead carriage, shown in this procedure, are of a DA610’s printhead carriage. The

DA615’s printhead carriage is very similar to that of a DA610. In addition, the new DA615s (S/N 131 or higher) have

a re-designed printhead carriage installed, which among other improvements, helps protect the cartridge-securing clip

from being bent during cartridge installation.

PRINTER PREPARATION

CAUTION: Until you have followed the steps below, never place your hands into the print area or touch any

of the moving parts of the printer while the printer’s power switch is ON.

DA615 Preparation

Make sure the DA615 is off-line. The START key is used to toggle between the on-line and off-line condition.

If the feed rollers are still turning, press the PAP key to stop the feed rollers from turning.

It is now safe to remove or install cartridges. Please follow the procedure for removing and installing cartridges as

outlined in this document.

AVOIDING HEAD CABLE DAMAGE

When inserting and removing ink cartridges, make sure the nose of the cartridge (Figure 1) does not make contact with

the Head Cable (Figure 2). The nose of the cartridge has a small protrusion of plastic (Figure 1). If this plastic edge is

allowed to contact the Head Cable, it will damage the Head Cable. Do NOT install or remove cartridges at an angle

(Figure 3).

Figure 1

Figure 3

Figure 2

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 53 54

Keine Kommentare

Rena DA615 Bedienerhandbuch Seite 15