Rena DA615 Bedienerhandbuch PDF herunterladen (Seite 9)

DA615 Operations Manual 3 Rev. 3/23/00

Printer Setup

Setting the Paper Transport System Height (Table Top Height)

The Height of the DA615’s table top, can easily be raised or lowered using the Paper Transport System Height Adjustment Knob

(5) to match the input of the printer to the output height of the feeder or conveyor. Turning the knob (5) counter-clockwise will

lower the height of the paper transport table. Turning the knob (5) clock-wise will raise the paper transport table. The range on this

adjustment is 10mm.

Setting the Paper Transport Pressure (Paper Thickness)

The paper transport pressure can be increased or decreased by turning the Paper Thickness/Transport

Pressure Adjustment Knob (4). Turning the knob (4) counter-clockwise will increase the pressure. Turning

the knob (4) clockwise will decrease the pressure.

To adjust the transport pressure, start with the pressure rollers raised high enough so that you can slide your

mail piece between all four upper pressure rollers under either H1&2 or H3&4. Slowly lower the upper

pressure rollers, increasing the pressure until the mail piece becomes difficult to pull out from between the

rollers.

NOTE: Too little transport pressure will cause slipping of the mail piece, which will distort images, and or

change print positions. Too much pressure can cause jamming, and or the mail piece may contact the guides

beneath the print heads and the image may be smudged.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 53 54

Keine Kommentare

Rena DA615 Bedienerhandbuch Seite 9