Rena DA615 Bedienerhandbuch PDF herunterladen (Seite 22)

DA615 Operations Manual 3 Rev. 3/23/00

A programming example

You want to change the set up from 6 lines per inch to 8 lines per

inch.

- Switch the printer on and take it off-line.

Programming mode - Press the “prog” key.

Activate required

menu field

- Use the “prev” or the “next” key to move to the “LINE

SPACING” menu choice. “LINE SPACING” is blinking.

Changing from menu field

to option field

- Press the “enter” key. The option field on the right with a “6” is

blinking.

Activate required option

field

- Use the “next” key to change the blinking “6” to “8”.

End programming mode - Press the “end” key. The changed value is now stored in the

settings under the selected "Setting No" and the printer is in off-

line mode again.

+ IMPORTANT! If you are using a Windows based program in conjunction with a

Rena printer driver, the Windows program must be used to control most of the

features in the printer. In other words, if you setup the printer, via the printer’s

programming mode, or RenaSet program, these settings will be over-ridden (reset) by

the Windows program.

When using a Windows program, in conjunction with a Rena printer driver, do NOT

set the Menu Feature: “Setting Locked” to yes. Doing so will cause image printing

problems and positioning problems. However, you should be sure the Paper Size is

properly set, and “Local Locked” within the printer’s menu. For more detail about the

Menu Features: Paper Size and Setting Locked, please see the chapter entitled

“DA615 Menu Feature / Option Definitions”

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 53 54

Keine Kommentare

Rena DA615 Bedienerhandbuch Seite 22