Rena Envelope Imager CS Bedienungsanleitung PDF herunterladen (Seite 44)

APPENDIX B

Envelope Feed Kit (optional)

This kit (Part # CS-5000) was designed to improve the feeding of # 9 and #10 envelopes,

by providing better support to the envelopes at the point of feed. The kit consists of two

side guides (fixed and adjustable) along with a new rear guide and two weights (one for

#9 and one for #10 envelopes). The two side guides can remain on the printer

permanently and will improve feeding of all types of media. The new rear paper guide

can be used with all media over 7-1/2 inches in width. For narrower media the smaller

(original) rear paper guide should be used.

NOTE

THIS KIT IS NOT A SUBSTITUTE FOR POORLY MANUFACTURED ENVELOPES.

ENVELOPES THAT ARE SEVERELY TWISTED OR DO NOT HAVE SQUARE

CORNERS WILL STILL PRODUCE POOR FEEDING.

ALL ENVELOPES SHOULD BE FANNED BEFORE LOADING IN THE PRINTER.

1. If present, remove the original

fixed and adjustable side guides.

These will be replaced by the

new fixed and adjustable side

guides from this kit.

2. Remove the rear paper support

guide. Set this guide aside as it

is used when feeding media

narrower than 7-1/2 inches.

1 2 ... 39 40 41 42 43 44 45 46 47 48 49

Keine Kommentare

Rena Envelope Imager CS Bedienungsanleitung Seite 44