Rena Envelope Imager CS Bedienungsanleitung PDF herunterladen (Seite 7)

SECTION 2

INSTALLING THE PRINTER

Section 2 – Installing the Printer

Before using the Envelope Imager CS printer the following must be done:

• Choose a location for the printer

• Unpack and assemble the printer.

• Install the Inkjet Cartridges

• Set up the feed on the printer

• Plug in the printer and connect it to the computer

• Install the Printer Driver.

Choosing a Location

The Envelope Imager CS should be placed on a sturdy worktable or cabinet at least 9

inches from any walls. Protect the Envelope Imager CS from excessive heat, dust,

and moisture – avoid placing it in direct sunlight.

Unpacking and Setup

Remove the Printer and its parts from the carton. Save the packing material. Remove

all packing tape. The screws that attach the various parts of the guides to the printer

are under the tape in their respective positions.

Begin by installing the Fixed Side Guide. It is

held in place by two screws [1]:

1 2 3 4 5 6 7 8 9 10 11 12 ... 48 49

Keine Kommentare

Rena Envelope Imager CS Bedienungsanleitung Seite 7