Rena Envelope Imager CS Bedienungsanleitung PDF herunterladen (Seite 9)

SECTION 2

INSTALLING THE PRINTER

Plugging in the Printer

1. Make sure that the Main Power Switch [3], is in the OFF position.

2. Connect the power cord from the power pack to the connector [4] at the rear of

the Printer.

3. Plug the power cord into the power pack and then plug the other end into a 115-

220 Volt AC, 50/60 Hz. Grounded outlet. A surge protector is recommended.

4. The Main Power Switch [3] can be turned on after you attach the power cord to

the Power Receptacle [4]

CAUTION

USE THE POWER SUPPLY PACKED WITH THE PRINTER.

DO NOT USE AN ADAPTER PLUG OR EXTENSION CORD TO

CONNECT THE PRINTER TO THE WALL RECEPTACLE.

DO NOT USE OUTLETS CONTROLLED BY WALL SWITCHES.

DO NOT USE AN OUTLET THAT SHARES THE SAME CIRCUIT WITH

LARGE ELECTRICAL MACHINES OR APPLIANCES.

Connecting to the Computer

Important: Before connecting the printer to

the computer, for the first time; please be

sure to follow the instructions for “Installing

the Printer Drivers”.

Power the printer off before

connecting/disconnecting the Parallel cable.

The Printer has both a USB [2] and a Parallel

Port [1] connection. The two ports are

located one above the other as shown.

 USB Users: Plug the USB cable from your

computer, into the printer’s USB Port.

 Parallel Users: Plug the parallel printer cable

from your computer into the printer’s Parallel

Port and latch the two locking clips.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 48 49

Keine Kommentare

Rena Envelope Imager CS Bedienungsanleitung Seite 9